When the transmitter starts the connection function, it cannot connect to the receiver, try to use the phone
SIM card pin inserted into RESET hole and pressed for 2 seconds to start the reset function, then try to connect.
How to solve the connection light keeps blinking, but no successful connection
Can I use it on my camera via an adapter cable?
yes
How to charge the charging box
The use of conventional cell phone charger can be charged, rechargeable battery, computer USB port
Wireless microphone charging how no response
Please tear off the bottom of the insulation tape
What does the low-cut function do?
Low-cut function can shield the surrounding noise, ambient sound, so that the sound is more clean
How do I connect the Maono WM821's windshields?
Align windshields and microphone jacks, then push in the direction of the Maono logo to complete the installation
Why the microphone is not connected successfully, the sound is not input to the phone
1. Please check if the connection is correct, TRRS (Four rings) connects to the phone, TRS (three rings) connects to the microphone
2. Please connect the audio cable to the microphone OUTPUT jack
3. When using the phone does not have a 3.5 MM headset hole, please connect the phone through the On the Go adapter cable, On the Go adapter cable, please use the original, to avoid connection failure and poor sound quality problems
WM821 recording sound is very small, how to adjust
1. Your wireless microphone is not successfully connected to the phone, you can use the recorder to record the sound, and then gently tap near the charging port, if there are sound fluctuations, the microphone is not successfully connected, please reconnect the device
2.WM821 has 6 volume levels, short press the receiver A or B button to adjust the volume of the corresponding transmitter
What is the difference between the WM821's Merged（MIX) and Split(AB) recording modes?
1.The receiver can switch between "Merged(MIX)" and "Split(AB)" by pressing the power switch button.
2.This allows you to record each transmitter onto separate channels on the output ('Split' mode) or combine the two into a single output ('Merged' mode). When it's in 'Split' mode, there will be two output level meters, when it's in 'Merged' mode, there will be just one.