Note: If the sound from your audio interface is very low, or there is no sound at all after connecting it to a computer, work through the steps below.
Part 1: Check the audio interface
1. Check the connections

-
Microphone: Connect the microphone to the audio interface with the TRS plug. Check that the plug is fully inserted and that it is in the correct jack.
-
Computer: Try a different USB port (do not use a hub). On a desktop PC, use a USB port on the rear of the case.
-
Phone: Try another audio cable. If you are using an adapter cable, make sure the adapter itself works.
Tip: Record a short test with the voice recorder app on your phone. While recording, blow on or tap the microphone. If the level meter moves, the microphone is connected correctly; if it stays flat, reconnect the devices or replace the audio cable.

2. Turn up the controls on the audio interface
-
Raise the volume controls to maximum first, to confirm that the audio interface itself is working.
-
Turn the Mic knob to maximum.
-
Push the Monitor fader to maximum.
-
-
Push Output to maximum (Audio Output Control). Leave it at maximum afterwards so you do not forget to turn it up again.
-
Condenser microphones need +48V phantom power. After connecting the microphone, press the 48V button to switch it on.

Part 2: Check the computer audio settings
Windows
Step 1: Open Settings.
Step 2: Select System.


Step 3: Select Sound, then open Sound Control Panel (More sound settings).

Step 4: On the Recording tab, set Maonocaster E2 as the default recording device.
Step 5: Double-click Maonocaster E2, open Properties > Levels, and set the level to 100.

Step 6: On the Playback tab, set Maonocaster E2 as the default playback device.

When the basic settings are done, record a short test with the Voice Recorder app (download it from the Microsoft Store if it is not installed) and check whether the input level is back to normal. If the problem persists, contact us at Support@maono.com.

macOS
1. Basic macOS settings
Step 1: Click the Apple menu in the top-left corner and choose System Preferences (on macOS Ventura or later, System Settings).

Step 2: In System Preferences, click Sound.

Step 3: Select the Input tab, choose Maonocaster E2 from the list, and set the input volume to maximum.

The input level meter now shows the incoming signal level.

Then select the Output tab, choose Maonocaster E2 as the output device, and set the output volume to maximum.
Part 3: Configure the software audio settings
For software-side audio setup, see